Atom topic feed | site map | contact | login | Protection des données personnelles | Powered by FluxBB | réalisation artaban
You are not logged in.
Dear Salome-Meca users,
After meshing a model, I used Wizard (Linear elastic) on Salome-Meca to create an Aster case. An Aster branch showed up in the Object Browser (attached picture). However, I would like to delete this Aster case and go back to the stage where I can use Wizard (Linear eastic) to create a new case again. How do I delete the Aster brach from the Salome-Meca Object Browser. Thank you very much.
- ffan
Offline
Hi,
I never try to use this command because I don't use the wizard but Salome->ASTK interfece and run analysis->Salome Paraview or GMSH post processing tool.
If is not possible delete direclty ASTER try to delete Linear-Static line on tree and after I suppose that yuo can run a new wizard.
Best Reagards
Jacopo
Salome-Meca 2017.02 (Intel Xeon 8 Core x 2 RAM 32GiB) Ubuntu 16.04 LTS
Offline
Thanks Jacopo.
- ffan
Offline