Welcome to the forums. Please post in English or French.

You are not logged in.

#1 2019-05-13 11:30:04

stefan_br
Member
Registered: 2019-03-31
Posts: 3

[SOLVED] Section properties of POUTRE defined with AFFE_CARA_ELEM

Hello everbody
I would like to double-check, if I have entered the correct section properties when defining a beam (poutre) with the command AFFE_CARA_ELEM - epecially when I use RECTANGLE HOMOTHETIQUE. Is there a way, that code_aster prints out in the postprocessing the section properties which have been used in the FE run?

Thanks a lot for your support.

Best regards
Stefan

Last edited by stefan_br (2019-05-19 21:19:50)

Offline

#2 2019-05-15 13:54:54

jlf
Member
Registered: 2007-11-22
Posts: 220

Re: [SOLVED] Section properties of POUTRE defined with AFFE_CARA_ELEM

Hello,

Yes it's possible. In INFO=2 in AFFE_CARA_ELEM command.

JLF

Offline

#3 2019-05-19 21:17:25

stefan_br
Member
Registered: 2019-03-31
Posts: 3

Re: [SOLVED] Section properties of POUTRE defined with AFFE_CARA_ELEM

Hi JLF

Thanks a lot for your reply. I have been looking for exactly this.

Best regards
Stefan

Offline

Board footer