Welcome to the forums. Please post in English or French.

You are not logged in.

#1 2019-05-18 12:01:25

nirmaljoshi
Member
From: Japan
Registered: 2018-10-12
Posts: 138

ERROR in documentation

Hi everyone, I am starting this thread to report error in documentation files. May be this post should be made sticky so that everyone can see and post it. I also hope the developers will update the documents.

Offline

#2 2019-05-18 12:03:54

nirmaljoshi
Member
From: Japan
Registered: 2018-10-12
Posts: 138

Re: ERROR in documentation

Location:
U3.11.01 Page 7

Error:
.........Non-linear statics SSLS111B...

Rectification:
SSLS111B should be SSNL111

Offline

#3 2019-07-11 15:59:14

argi
Member
From: Bidart FRANCE
Registered: 2019-01-10
Posts: 12

Re: ERROR in documentation

POSSIBLE ERROR in U4.81.01, Documentation for CALC_ELEM, page 15/27

EPSP is "Déformations anélastiques aux points de Gauss" as is written on the documentation, or is it the PLASTIQUE STRAIN?
Regarding the symbol I would say that it is the plastique strain and not anelastique strain!

In Documentation for CALC_CHAMP, page 14/31 there is the same situation!

In addition, in u4.83.02, Documentation for CALC_FATIGUE, in page 13/27 EPSP_ELGA is considered as plastique strain!

Can someone clarify my doubt?

Thank you!

Last edited by argi (2019-07-11 16:16:51)

Offline

#4 2019-07-16 14:43:31

Anirudh
Member
Registered: 2017-09-11
Posts: 230

Re: ERROR in documentation

Hello,
There seems to be a typographic error in AFFE_CARA_ELEM documentation(u4.42.01) Page 31.
The error is under Opérande CARA = ’ANGL_VRIL’.
The text is , "...transformant ( P , x3, x 2, x2 ) en ( P , x3, y3, z3)"...
whereas it should be "...transformant ( P , x3, y2, z2 ) en ( P , x3, y3, z3)..."


Regards
Anirudh

Offline

Board footer