Welcome to the forums. Please post in English or French.

You are not logged in.

#1 2020-12-27 16:13:33

lskrinjar
Member
Registered: 2015-10-16
Posts: 29

MACR_CARA_POUTRE for hollow symmetrical sections?

If I understand it correctly you cannot use MACR_CARA_POUTRE when modeling a 1- or 2-times symmetrical hollow section to calculate properties of a section (ie. hollow rectangular/square tube - modeling only half or 1 quarter of a section). If this is correct, this restriction should be written in the documentation ("code-aster.org/V2/doc/v11/en/man_u/u4/u4.42.02.pdf").

Last edited by lskrinjar (2020-12-27 16:16:29)

Offline