Welcome to the forums. Please post in English or French.

You are not logged in.

#1 2012-03-24 14:01:22

dbpatankar
Member
From: Roorkee, Uttarakhand, India
Registered: 2010-05-22
Posts: 172

View orientation of beams and other elements

How to view orientation of beams? I tried the View3D from Eficas in salome_meca without any luck.

The reference document mentioned in one of the earlier posts (U10410A ) is also not available to view.

Can anyone point out the answer? Or any mistakes I might be doing while using View3D?

I am trying to view it using following ways :

1) Open rmed file in samole_meca and then open eficas and load comm file. Then View3D for affe_cara_elem.
2) Open geometry in samole_meca and then open eficas and load comm file. Then View3D for affe_cara_elem.
3) Open Mesh in samole_meca and then open eficas and load comm file. Then View3D for affe_cara_elem.

Am I making any mistake?

I have a multistorey frame with beams and columns and I want to test if the orientations are considered properly or not.

Offline

Board footer