Welcome to the forums. Please post in English or French.

You are not logged in.

#1 2018-07-31 09:16:27

MachCone
Member
Registered: 2018-07-18
Posts: 6

<AsterStudy> Can't see group in POST_RELEVE_T and POST_ELEM

Hi all, I am trying to create output tables using POST_RELEVE_T and POST_ELEM operators. However, I can't see the groups I have created when I am setting up these operators using AsterStudy. At the same time, the same groups can be seen and selected under the BC and Load operators. Can anyone shed some light on what is going on here?

Offline

#2 2018-07-31 20:47:01

AsterO'dactyle
Administrator
Registered: 2007-11-29
Posts: 312

Re: <AsterStudy> Can't see group in POST_RELEVE_T and POST_ELEM

Hello,

Did you choose a model ?
These commands need to have a reference to the mesh, by the model for instance


Code_Asterの開発者

Offline

#3 2018-08-01 17:00:21

Thomas DE SOZA
Guru
From: EDF
Registered: 2007-11-23
Posts: 3,066

Re: <AsterStudy> Can't see group in POST_RELEVE_T and POST_ELEM

Hello,

Regarding your problem, this is a known issue referenced in the embedded help of AsterStudy:

POST_RELEVE_T command

During the edition of the POST_RELEVE_T command, the link with the mesh is not activated until the modifications of the ACTION factor keyword or the whole command are validated.

TdS

Offline

#4 2018-08-02 03:06:50

MachCone
Member
Registered: 2018-07-18
Posts: 6

Re: <AsterStudy> Can't see group in POST_RELEVE_T and POST_ELEM

Thank you very much for your replies, AsterO'dactyle and Thomas DE SOZA. I managed to find a way around the problem accordingly.

Offline